Reznor RA 140 Guide de dépannage Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 52
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Form I-RA/D 140/235 (Version A), Page 12
Barometric Draft
Regulator
Tee with Cleanout
Barometric Draft
Regulator
(alternate location)
Oil Feed
Line 3/8
O.D.
Copper
Tubing
to Inlet
on
Burner
15 ft (4.6M)
Maximum
Lift (pump
to heater)
Room
Thermostat
OIl Fill/Vent
Water/Sludge
Drain
Constant
Rate Fuel
Pump
Return
Line
OIl Line Filter with
Vacuum Gauge
Suction Line (1/2 Std Pipe)
Foot Valve and Strainer
At least 6 (152mm)
200/275
gallon
(757/1040
liter)
Oil Supply
Tank
Approx 12 (305mm)
Typical
Installation
Supply Lines
Installation
Continued
as illustrated. With the vacuum gauge mounted on the outlet side of the
filter, the gauge will indicate any suction line restriction including a dirty
filter. A pump inlet manifold is supplied for direct connection of the filter
to the inlet of the pump.
The 50 psi relief valve supplied with the pump and a return line of 1/8”
NPT black iron pipe must be installed as illustrated.
The discharge line between the valve on the outlet side of the fuel pump
and the heater should be 3/8” O.D. copper tubing with a minimum of 1/32”
wall thickness with 45° flare fittings. The discharge line must continually
rise. A lift height of up to 15 ft (4.5 M) is acceptable with a maximum total
length of 60 feet (18 M) of tubing.
Do not install manual valves in the supply line.
Connect the fuel line to the heater at the connection on the corner of the
service tray.
All piping should be protected from possible damage and be rigidly fas-
tened in place in a workmanlike manner. Do not use TEFLON
®
based pipe
dope or TEFLON
®
tape at the connections in an oil line. Use an oil-resis-
tant pipe dope. Do not use union connections in the suction line (line be-
tween the oil supply and the remote pump).
NOTE: Care must be exercised to ensure airtight connections.
Return Line
Discharge Line (por-
tion of supply line
from pump to heater)
Supply Line
Connections and
Support
Suction Line (cont’d)
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Commentaires sur ces manuels

Pas de commentaire